Leave Message-Sitemap-About UsWelcome to Eric Bearing Limited!
Eric Bearing Supplier Co.,Ltd mobile site

Home > News >

18
2021.Mar

Classification of surface hardening technology for imported bearing materials

When we understand the bearing manufacturing process, we usually find that the bearing will harden the surface of the material, which can strengthen the bearing surface and make the surface of the bearing material beautiful and smooth. ERIC BEARING LIMITED mainly shares the classification of surface hardening technologies for be...
17
2021.Mar

SKF Thrust Roller Bearing

Thrust roller bearings mainly bear the combined axial and radial load of axial load, but the radial load shall not exceed half of the axial load. Compared with other thrust roller bearings, the friction factor of this kind of bearing is relatively somewhat Low, the speed is relatively high, and has the performance of mobilizatio...
16
2021.Mar

NSK successfully developed bearings for competitive tennis wheelchairs

Nippon Seiko Co., Ltd. (Headquarters: Shinagawa-ku, Tokyo, Representative: Toshihiro Uchiyama, Executive Director, Representative Director, NSK, hereinafter referred to as NSK) to Tokyo Institute of Technology (Tokyo Metropolitan Government) commissioned by the Japan Sports Bureau Black area) Provide special bearings for competi...
15
2021.Mar

When is the better time to change the bearing oil

As everyone knows, grease plays a very important role in the use of bearings. Then someone will ask, is it possible to use grease to lubricate bearings indefinitely? When and how much oil should be changed? In fact, these problems are complicated problems of bearing maintenance technology. To the question of whether grease can b...
12
2021.Mar

Material and Control Affecting the Life of IKO Bearings

The early failure modes of IKO bearings mainly include rupture, plastic deformation, wear, corrosion and fatigue. Under normal conditions, they are mainly contact fatigue. In addition to the service conditions, the failure of bearing parts is mainly restricted by the hardness, strength, toughness, wear resistance, corrosion resi...
11
2021.Mar

How to keep and install NACHI machine tool spindle bearings

Whether the NACHI machine tool spindle bearing is installed correctly determines the life, accuracy and performance of the bearing. The steps to install the spindle bearing are as follows: a first check the shaft and bearing seat b unpacking and cleaning c installation d confirmation after installation. Bearing seat inspection T...
10
2021.Mar

Aeroengine IKO Mmain Shaft Bearing Sliding Part

The main shaft bearing is an important part of an aero engine. If the main shaft bearing of an aero engine fails, it will directly affect the normal use of the engine. It can be seen that if the main shaft bearing fails, the consequences will be disastrous. This is why Eric Bearing Limited mainly explains the following IKO spind...
09
2021.Mar

FAG Bearing Abnormal Sound Detection Method

There are two ways to detect abnormal sound of FAG bearings. One is the noise detection method based on acoustics, and the other is the detection method based on vibration. 1. Detection method of abnormal sound (1) Noise detection method In a silencing environment where the basic noise is less than 20db, a high-quality microphon...
08
2021.Mar

Causes of High Temperature of TIMKEN Bearings

High bearing temperature is a common and harmful fault of rotating equipment, which will reduce the service life of the bearing and increase the maintenance cost. When the temperature rises rapidly and the temperature exceeds the standard, it is easy to cause unplanned shutdown or reduced load operation of the unit. Economic ben...