Leave Message-Sitemap-About UsWelcome to Eric Bearing Limited!
Eric Bearing Supplier Co.,Ltd mobile site

Home > News >

Timken Tech Tips: how to remove and install

Source: FAG bearings  Tags: News

Properly removing and installing hub unit bearings not only can enhance the performance and longevity of hubs, but also will benefit the axles and wheels. The Timken Co. offers technicians the following advice on removing and installing hub unit bearings

 

1. Hub unit bearing removal Begin by raising the vehicle up and removing the lug nuts and the wheel. Remove the brake caliper and rotor. The caliper should be supported and not hanging freely. Next, remove the axle nut using an axle nut socket. The vehicle manufacturer’s instructions should be used to determine proper nut replacement. If possible, disconnect the ABS sensor wire from its mating connector point. This is usually located in the wheel well or on the chassis frame. Also, disconnect the sensor wire from the clips that are used to properly position the sensor wire in the wheel frame. (Before removing, be sure to make note of the current orientation and positioning of the sensor wire and bearing.) Remove the bolts that attach the bearing to the steering knuckle. A puller may be needed to remove the hub assembly from the knuckle. Be careful not to damage the knuckle or axle shaft.

 

2. Hub unit bearing installation First, insert the new hub assembly into the steering knuckle. Check the positioning of the splines on the axle shaft as the hub assembly is inserted into the knuckle. Carefully position the two components so the splines are not damaged during the installation. Never force the hub assembly on the shaft and never hit it with a hammer or other tool. Next, torque the knuckle-bearing mounting bolts to the vehicle manufacturer’s specification using a torque wrench. Don’t use an impact wrench because it does not reliably use the proper torque.  TIMKEN 6200 bearing in stock , pls click here : 


If possible, connect the new ABS sensor (it comes already attached to the new bearing) to its mating connection point and clips in the wheel well and frame area. Install the axle nut. Tighten the nut to the vehicle manufacturer’s torque specification using a torque wrench. Again, an impact wrench is not recommended. Replace the brake rotor and brake caliper. All components should be clean of debris and burrs. Replace the wheel and torque the lug nuts. Follow the vehicle manufacturer’s recommendations regarding torque specification and re-torque requirements.