Leave Message-Sitemap-About UsWelcome to Eric Bearing Limited!
Eric Bearing Supplier Co.,Ltd mobile site

Home > News >

The solution of repair FAG bearings after cleaning and wear

Source: FAG bearings  Tags: News

No matter what, it will wear out a bit after use.

FAG bearings are the key equipment of the ultrasonic cleaning machine system. Because the imported bearings of the cleaning machine have extremely bad working conditions, they need to be operated under continuous shock, vibration, and overload, and the service life is more than 15 years, and the reliability is extremely high. Therefore, the use of ultrasonic cleaning machines puts forward higher requirements for the planning and production of bearings.

The correction position is accurate and sensitive, the correction amount can control the accuracy, and it can also be corrected on-site without crashing. After the correction, the position can be accurately restored to size by tool grinding. The cleaning machine is used to grind cement, coal and other construction, chemical, ceramics and other industrial raw materials. It has a series of advantages such as small size, light weight, small area, low power consumption, energy saving agreement reached more than 30%, and long service life.

During the correction process, FAG bearings have been at room temperature without internal stress, no thermal deformation, cracks, annealing, softening appearance, and no potential effects of breakage or cracking. High contact strength, no falling appearance, no hard spots, high surface finish, and adjustable hardness. Suitable for low carbon steel and low carbon alloy steel, medium carbon steel and medium carbon alloy steel, high carbon steel and high carbon alloy steel, high strength alloy steel, stainless steel, cast steel, cast iron, copper and copper alloy, aluminum and aluminum alloy , Zinc and zinc alloys, chromium, nickel, chromium-nickel steel and unknown materials are corrected.   FAG precision bearing B7014-E-P4-UL online , if you are looking for , pls click here to learn more : 

Solutions to Overheating of Motor FAG Bearings

1. The FAG bearing is damaged. Solution: Replace.

2. Sliding FAG bearing lubricating oil is too little, there are impurities or the oil ring is stuck. Solution: add oil, change new oil, repair or replace oil ring.

3. Rolling FAG imported bearing grease is too little, too much or there are impurities such as iron filings. Solution: The capacity of FAG imported bearing grease should not exceed 70% of the total volume. If there are impurities, replace it.

4. The FAG imported bearing and the end cover are too tight or too loose. Solution: Process FAG imported bearing chamber when it is too tight, and insert a steel sleeve in the end cover when it is too loose.

5. The belt is too tight or the coupling is poorly assembled. Solution: Adjust the belt tension and correct the coupling.

6. Poor assembly of motor end covers or FAG imported bearing covers. Solution: Install the end cover or FAG imported bearing cover stopper, install it flat, and tighten the screws.

7. The shaft and the FAG imported bearing are too tight or too loose. Solution: Re-grind when it is too tight, and insert sleeve for the shaft when it is too loose.